It is time you learn how to make a grill cover out of a tarp. A barbecue grill comes in handy when you want to prepare delicious meals for your friends and family especially during summer when the weather is favorable.
The grill normally stays outdoors and this means that it is likely to be affected by elements. When this happens, it may start to rust and it will not be in the best condition even if it is made of stainless steel.
It is possible to scour off the rust but why let your precious cooking equipment get to that point? This is why you need a cover.
You can buy a grill cover in the store but you can also make your own at home. Let’s look at how you can make a DIY grill cover from a tarp.
Table of Contents
Here are the steps to follow to come up with the DIY grill tarp.
1. Get the equipment you need ready
You need to gather your equipment and tools before you do anything. These will be tarps, bungee cord, and duct tape.
The tarps need to be large enough to cover the section of the grill that you want to protect and heavy enough to withstand elements since it will be outside covering the cooking appliance.
You can measure it and since you know (or you don’t in which case you can measure it too) the size of your outdoor grill, you will be able to determine if it’s big enough to do the job required.
2. Start cutting
Now that you have everything ready, put the tarp over the equipment. Check the corners where it should have folded over. Cut off the additional parts of so you are left with enough to go over the grill.
This is where your duct tape comes in handy. Lay it over the seams.
3. Flip the cover
You now have your cover, you just have to flip it over so you can use the side that is not all covered with duct tape. The inner side will give you a beautiful looking protector for your equipment.
4. Thread it off
Remember this protective wrapper will stay outside and so it can be blown away by the wind and leave your grill exposed to elements. To prevent this from happening, you need to tie it down using a bungee cord or any other securing method.
Take one side of it, locate the metal grommets on the tarp and thread through it. Finish off by tying off the ends of the bungee rope.
- Avoid placing your barbeque equipment in direct sunlight because it will shorten the life of your protective wrapper even if it has UV protection. It is advisable to keep the equipment and the wrapper in a shade.
- Do not puncture your tarpaulin if you don’t have to because the holes cannot be fully and effectively covered which will give you a shorter period of using it.
- Choose the right tarpaulin. They come in a variety of types and sizes and you need to get the heavy-duty ones that will offer full protection from weather elements and also from ultraviolet rays.
One secret to having the Weber Genesis grill cover which is cheaper than the original one, is to know how to make a grill cover out of a tarp. You can’t leave your beautiful and costly barbeque equipment unprotected.
Sometimes, when you buy one, you may struggle to get the correct size for your cooking equipment. Other times, it may be too costly.
The method outlined here is quite simple and doesn’t require a lot of materials. Once you have your tarpaulin, which is the main tool, duct tape, and bungee rope, you are good to go.
Since you want something that can last a while, it is advisable to get a good quality tarp. A heavy one is perfect because it will shield your equipment from harsh weather elements as opposed to a light one.
Choosing a large tarp helps to fully protect the cooking appliance. You can always cut off the excess putting on duct tape.